Hello, I'm on Solidworks2017.
Is there a constraint to make two sides of a diabolo tangent on a cylinder (the two blue faces on the red side)?
Does this exist on the more recent versions 2019 or even 2020?
Thank you.
Hello, I'm on Solidworks2017.
Is there a constraint to make two sides of a diabolo tangent on a cylinder (the two blue faces on the red side)?
Does this exist on the more recent versions 2019 or even 2020?
Thank you.
Hello
I enclose my solution.
In the sketch of the diabolo I draw the circle corresponding to the Ø of the cylinder (tangent to the V). then in the assembly it will be necessary to constrain the cylinder with the sketch of the diabolo.
View files
Thank you very much for this solution.
Hello @pascal.babel,
If you are satisfied with the answer you gave @contact.be_1, please designate it as the "Best answer" in order to close this question.
Kind regards