Hello everyone,
I have a little problem.
I'm looking to rearrange the numbering of the holes on a drilling table.
As you can see in the attached image, the numbers don't follow each other. How do you expect my machinist to manage!!!!
Do you have a solution? Or an idea to get around this problem?
Thanks in advance
Fred.
Hello, I'm having trouble keeping up.
The holes are increasing from left to right and from bottom to top.
3 8
5
2 7
4
1 6
What exactly do you want to do?
Hello, see the proposed solution here:
https://www.solidsolutions.co.uk/blog/2014/05/ordering-holes-in-a-hole-table/#.V4Yi8ck6_qA
There's even a video at the end.
I would like to arrange them from left to right and from bottom to top
5 6 7 8
1 2 3 4
Too bad it's only the .PL technique that works. 90x a drilling table to edit...
No reason to do them one by one, by the way.
Select your piercings in the order you want!
That's what I did at the beginning....