Zone Repeat

3D Design
1

Good evening
I have just seen a phenomenon that challenges me....

In a zone repeat, I have a plate in which I do a cylindrical and then rectangular material removal, and then a zone repeat.

He doesn't  repeat the 2 functions everywhere???

Then, if the sketch of the rectangles does not exceed that of the circles, the repetition fails???

Do you know how to explain it to me?

Thank you.

2

Good evening

A small picture would be welcome to help us understand

Kind regards

1 Like
3

Good evening

Which version are you on and can you share your file?

4

Good evening

Thank you for your answers and your interest.

I had tried to paste the images into the text, but it didn't work.

 

 


sans_titre1.png
5

Second image


sans_titre2.png
6

Good regards,

Without a c file is hard to say.

Your circles are close to the edge.

Probably a tangent of the circle  of the last repetition with the edge.

Julia 

7

I believed in that at first but no. If I change the sketch of the rectangle and it's completely inside the circle, it crashes. By the way, it only takes one to stick out for it to work.

I put the file, it's SW2018.

If you change the sketch of the reectangle from 40x10 to 20x10, the repetition no longer works!


zone.sldprt
8

Hello

You need to check the "Geometry Repeat" option.

Kind regards


zone.png
4 Likes
9

Hello

Thank you for your reply, and it is solves the problem for this plate but on my actual piece, no.

Because I think it has too complex ext shapes.

A+