Hello
In assembly, I have a repetition of parts (screws) controlled by a repetition function of the main part. So far no worries.
The number of pieces changes (from 5 to 7 screws). But I don't understand why sw12 goes into hidden mode when I switch from configuration 5 to configuration 7.
Is there a way to avoid having the hidden components?
Hello
This is a bug reported at SolidWorks, a priori no solution:
https://customerportal.solidworks.com/eservice_enu/start.swe?SWECmd=InvokeMethod&SWEMethod=GotoRecord&SWEService=SWGotoRecord&ViewName=SW+All+Defects+List+customerportal+-+Search&BusObject=Product+Defect&BusComp=Product+Defect&Id=1-W04TIL&SRN=
SPR #: 591216
Some instances of a linear component pattern are hidden after the instance value is changed in a design table or via configure feature & then different configurations are shown
Thank you pl. I don't know how you manage to find the info. Too strong.
Do you give training? I register...
And for the pb, bad luck for me.
@opiep27: Knowledge Base Search: https://customerportal.solidworks.com/SWSearch/search.aspx?SRN=
This link requires logging in to the SolidWorks Customer Portal
Yes, but I can't find the right term to get the answer quickly...
This is where all the difference lies. We therefore recognize the effectiveness of @.PL!
;-)
A good level of English helps ;-)
@pl: you installed sw in English to have the right tooltips and the names of the functions?
I had it in English at one point, but all the functions and plans (everything in the tree) were in English too, so not practical when a colleague takes over one of your parts! But I have a good level too because I did part of my studies in English ;-)