Hello
I'm getting started with sketch blocks.
On the advice of an eminent colleague of this forum I managed to create a block and save it. (phew !!)
On the other hand, I don't know how to reinsert it, either in the same sketch or in another room, if for example I make a schematic representation.
Kind regards
Hello.
The best would be to create a library (right panel) to be able to drag and drop the sketches.
Well seen Philippe B
no better
Same as a library room
@+
Hello
That's exactly what needs to be done.
Here is some info about the design library.
https://www.youtube.com/watch?v=uHDvm8yli_U
may the force be with you.
Thank you for this info
Question is it possible to put several blocks in a new sketch or in this case should we go through schematic representation.
I'm newbee on the blocks so don't bang my head :-) although the force be with me.
Yes you can
Thank you gt22
I set myself goals for improvement: a bit like the Belgians said this morning (once) you have to have a goal in life
Thank you all
I continue :-)