[ RHINOGOLD ] Curve projection on surface!

Out of category
1

Hi all

I would like to make a curve projection on a surface, but I can't. ( yet I select the curves, then I go to projection etc ... )

Could you help me or guide me?

Thank you.

Kind regards.


image_rhinogold_pour_forum_lynkoa.jpg
2

Hello

Check that the surface to be sprayed does not exceed the outer diameter of the ring.

Most software crashes in this case because it cannot project everything onto the receiving object. Tried with a narrower top plane shape.

Also try to project in two times. I don't know rhinogold but MODO901 which has a somewhat similar logic.

Kind regards

PS: Friendly suggestion: although you have your place on the Solidworks forum: I wonder if it wouldn't be better for you to also register on a RHINO forum because at each forum these big guys of the software.   :-)  ;-)

3

@Zozo_mp I actually succeeded, I started my piece again and I did a little manipulation and presto... Xd

(It's a multi-software forum here, isn't it? and which solidorks forum?)