Rotate Drawing View

Out of category
1

Hi all

A quick question about the drawings.

I would like to incline a view of a very specific value. I'm right-clicking, rotate the view.

I can rotate my view by dragging my mouse , but only in 45° increments.

On SW2016 I remember that it was possible to enter a precise value with the keyboard in an input window. I'm now on 2017 SP5 but this input window didn't seem to be able to do it anymore.

Is there an option or checkbox to find the entry?

I want to be able to tilt my view 12.25°

 

Thank you

2

Hello

The tool you are looking for is located above the drawing, see attachment.


rotation_vue_mep.jpg
1 Like
3

Correct!
But it's precisely this "rotate the drawing view" window that doesn't show up anymore at home...

4

The window may have been dragging out of the display area.

Have you tried to reset your Solidworks settings to default (by saving them beforehand)?

5

Try this solution: http://www.lynkoa.com/forum/3d/la-fenetre-modifier-orientation-des-vues-ne-s-affiche-plus

1 Like