Selecting a Dimension in a Sketch

Out of category
1

Hi all

I have a small question, probably simple, but I can't find the answer...

I just switched from 2017 to 2020, and when I create a sketch, by clicking on a dimension, it is open for editing directly, instead of just being selected.

Do you know where, in the settings, I can change this?


sans_titre.png
2

Hello

This should help you:

2 Likes
3

I ticked both boxes, it's back to normal:D

Thank you!

4

I claimed victory too quickly. It was good on a sketch, then it came back.

Both boxes are always checked

5

@n.Morette 

have you tried to turn off SW and the pc

and everything turned back on 

to see if your modifications are well taken into account

@+

6

@gt22

yes I restarted the pc just in case

7

Hello here,

Looked at your toolbar and disabled "Instant2D".

@+


instant2d.png
1 Like
8

There is still a shit in SW, because even after unticking and rechecking the boxes, it no longer supports the modification. even after restarting SW.

On the other hand, there was the "Instant2D" icon that was activated.

1 Like
9

 @FUZ3D

by disabling the instant2D, it looks good

I noticed that there was the same thing with the 3D moment.

if I turn off Instant3D, I can no longer see my dimensions in the 3D model by simply clicking on the sketch in the tree 

1 Like
10

 @FUZ3D

If there were only 1 ;-)...; -)

@+