Beam simulation

3D Design Volume Model
1

Hello 

 

I am in the process of simulating the resistance of HEA 300 beams (see attached file), I would like to apply on each beam two point loads of 1.5 Ton.

 

I can't do the simulation. 

 

Thank you


assemblage1.jpg
2
Hello, where is the problem exactly? For the simulation, it's better to isolate a beam to do the calculations. I imagine that it is for a buckling calculation, in this case you have to fix the lower part and apply the load on 2 vertices or 2 points at the top.

. https://youtu.be/_D6fhjydP1Y

3

For HEA 300 a load of 1.5 tons

This is like trying to calculate the load of a mosquito on a railway rail

See this link

INFLECTION

jean.lamaison.free.fr/flexion.html
 

To calculate the deflection and stress of the beam, enter the data ...  Weighting coefficient ( 1 = no weighting 1.33 = static load 1.5  ...

@+;-))

 

1 Like
4

Hello, for this kind of calculation, I create 2 surfaces using a separation line where I want to put the load (circle), then fix the two ends of the pourte and apply the two loads on the separated surfaces.

I've never had too many problems for this type of study.

Gt 22 is right, otherwise it's a like trying to calculate the load of a mosquito on a railway rail, it's not ready to move.

Kind regards

2 Likes