No need for a one-hour tutorial, a simple answer will suffice, thank you.
tole.png
The question is for the 135° sketch?
or just the box?
for the 135 sketched plie: sheet metal with folded edges.
With a shift at the end so as not to have any interference from the sheet metal.
for the rest: a flat sheet metal and then "sheet metal bent on edge"
edit: with an ex. But I didn't look too much at the overlapping corners on your ex...
2015-03-02__boitier.sldprt
@Opiep27 you can a screenshot please
I didn't understand @'s request. Pl
@+ ;-)
Yes that's also what I thought I understood but to be very sure ;-(
@+;-)
I posted this tutorial
which explains the basic sheet metal tools
http://www.lynkoa.com/tutos/3d/les-outil-de-tolerie
This type of piece is described there, among other things
@+;-)
If you can't do it, come back to us, I'm used to this kind of play.
Good luck!
Thank you very much, it wasn't very complicated!
As for the shift, I imagine that we can only do it in this direction and not in the other direction? = the opposite odds?