ccarton
September 2, 2015, 2:48pm
1
Unable to perform an operation (+,-,x) within a constraint dimension to modify the dimension (in a sketch dimension its walk).
Exp: the odds are 245.5, I want to have 245.6, so I'm doing in the ratings: 245.5mm+0.1
And it hasn't worked since 2015
Is this a bug or an option to check?
Thank you
sans_titre.png
1 Like
opiep27
September 2, 2015, 3:11pm
2
Remove the mm, it should pass normally.
edit: I just tested on SW15 and it goes with your syntax. Forget my answer.
3 Likes
pl
September 2, 2015, 3:20pm
3
EDIT: a priori the problem has been corrected! See the 4th and 5th messages.
Hello
This is a known issue that doesn't have a solution when Office 2013 (or higher?) is installed.
Summary:
Math operations in pop up distance mate dimension box do not solve with office 2013 installed
7 Likes
Hello
At home it works, what does it look like by omitting the "+":
22mm5
SolidWorks must do the addition automatically
cote.jpg
3 Likes
Hi PL.
What surprises me is that this bug is supposed to be fixed since Solidorks 2013 SP3.
I don't have the 2013 version of the office pack to test at home, maybe someone who would be in the same configuration could tell us if they have the same problem.
Mick
2 Likes
pl
September 3, 2015, 8:04am
6
Mea culpa, I read too fast indeed, on the SolidWorks website, it is written:
= Improvement: No
But it is also written:
Status:
Closed (Implemented)
= Status: Closed (Implemented = software update that fixes the issue)