Hello
Until now, I did not put annotations or welding symbols on my plans for mechanically welded parts.
Today I'm trying to put on the cartridge, a generic information for the soldering....
What do you put on your plans?
@.PL,
Is it an "internal standard" where you extracted it from a standard?
1 Like
That's a good question, I think it' s empirical.
According to the GDI (also in the PJ):
soudure_gdi.jpg
2 Likes
Hello
Yes, the standard says that the weld seam must be between 0.7 and 1 times the thickness of the thinnest sheet metal to be welded.
May the force be with you
3 Likes