Hello
We encounter a problem during drawings.
we lose the sub-assembly or detail plan numbers in the nomenclature, this is replaced by the designation, we have to take them all back and put them in manual.
Thank you for your help
Hello
We encounter a problem during drawings.
we lose the sub-assembly or detail plan numbers in the nomenclature, this is replaced by the designation, we have to take them all back and put them in manual.
Thank you for your help
Can you give us a screenshoot as an example?
Hello
Wouldn't this be due to a bad configuration of the nomenclature quite simply?
@+
What sp do you have on your 2014 version
It's a studied version
your (sub)assembly are all made in the same version or have been updated to SW2014 version
@+ ;-)
The column of the nomenclature should be linked to the designation and not to the part number I think