Hello, seriously
I can't find a way to orient my chambering groove to rotate it 90°
What did I skip?
capture_rainure.png
Hello, seriously
I can't find a way to orient my chambering groove to rotate it 90°
What did I skip?
Your grooves are not part of the same sketch as the others?
apparently you want to move them with a function, you should rather move it to a sketch by creating a new oneHi @ Gerald
This link should suit you
http://help.solidworks.com/2014/french/SolidWorks/sldworks/c_detailing_for_sketch_slots.htm?format=P
@+ ;-((
@ nicolas no i have 2 different piercing function
@gt22, no it's for sketches not the chambering in the drilling function (new in 2014)
it still talks about the X Y position but where is that?
Hello
In fact, when you go to the "position" tab and place your groove, you can then constrain the axis to put it vertical!
And yes, SolidWorks is not going to do everything for you!
@ Lucas I hadn't seen there is only one that has an axis!!
Too strong
there I think NO
To manually place a centering axis in a groove, select Groove Centering Axes under Manual Insert Options in the Centering Axis PropertyManager .
Grooves in drilling tables
You can include grooves in the drilling tables:
@+ ;-((
I say IF
It's stupid as hell but in SW 2014 it's done like that too, and I can't say for 2013 because I didn't have the function in the piercing function
it's not cool not to listen or read the instructions given
it's not cool ;-))
@+ ;-((