Hello
When I carry out a static study on a part comprising a beam based on a square tube, the results are displayed on a cylindrical tube.
This does not change the relevance of the results. But is it possible to set any parameter so that the results on square tubes are displayed in square tube?
Hello
Isn't it simply a problem of the level of detail of the generation of curves?
In the options menu, there is plenty to do :-)
I can't find any options in this sense, and visually the curve generation is done around a circle (and not a square)
Hello
There is a checkbox.....
Right click on your constraint result, then parameters, definition, and there you will get:
RENDERING OF BEAM PROFILES (SLOWER).
There you go
Thank you!