Hello
in an assembly I want to make a symmetrical part, so far so good I know how to do it, but on my left part I want a G to be engraved and on my symmetrical part a D, how to do it?
Thank you for your help.
Cdt
Fred.
P.S: I'm working with SW 2012
Hello
See FLOP's response here:
http://www.lynkoa.com/forum/cao/symetrie-d-une-piece
And the tutorial he created here:
http://www.lynkoa.com/tutos/cao/creer-une-configuration-symetrique-dans-une-piece
4 Likes
Hello
In my opinion the easiest would be to make configs in your room, you make a right and left config and then the marking that goes well on it. I do a sym in the room and a removal of material so that only the desired part remains. If you put your coin in the question, I'll do it for you so you can see...
2 Likes
Hello
Yes, the easiest way is to make the engravings after having made the right and left jams.
may the force be with you.
Thank you all, FLOP's response via .PL worked.
Cdt.
Fred