In Tools/Options/Document Properties under Table/Review I set up my drawing for numbers like Review.
The problem is that the Revisions in my design office are called R0/R1...... R9.
Problem: I would like to add the "R" in the REV column but
SolidWorks doesn't keep it for me if I insert a new table into a document
SolidWorks doesn't add the R if I do "add a revision"
Anyone have a tip? Have there been any improvements on this side under SW 2014?
Regarding the formatting of the table, I have parémetrée a font [10] and a [Nomal] style for the column headers of the table and then for the addition of Revision I would like a font of [12] with a [Bold] style.
Problem: If I add a new table this "customization" doesn't remain.
It's a BUG, anyone are also experiencing this problem?
I don't think it's possible to keep the "R" in the revision box, because in the document properties, you only have 2 possible choices for this column (see attached image). Inserting a new table into the document makes solidworks configure this table with the properties of the document (either A - B - C etc. or 1 - 2 - 3 etc.) no customization possible.