Hi all.
My question is in the revision table template, I would like to insert a blank line. So I did a line insertion and saved my revision table but when I re-insert it in my drawing my line disappears. Can you help me
Personally, I find the revision tables in SolidWorks not TOP (to be polite !!!).
I manage the clues via custom properties in the room.
Hello
I also manage clues like flegendre. which allows me to evolve my nomenclatures at the same time.
1 Like
Thank you for your answer but it doesn't answer my question too much:)
Have you registered your table in .sldrevtbt?
Forget it, my question is stupid. It's offered by default in .sldrevtbt
On the other hand, every time I try to record with an additional line, it disappears as soon as you reinsert your table. I even tested by putting spaces or writing in one of the lines. Same result.
Whereas if you add columns and save, it remains... Dirty story.
You can try to "trick" the system by creating a table as you want and then integrating it in place of the revision tables. On the other hand, you will no longer have the option "right click, new revision".
1 Like
Thank you for your answers, we found out how to do it. The trick is in your DRWDOT master file, you insert a new line and you're done. There you go
1 Like