Hello
As the title says, I want to do a 1/4 pitch thread but this part will be 3D printed .
However, if I am not mistaken, with SW2013 this thread can only be representative.
I've seen tutorials where they use the "thread" function, which I can't find from the 2013 version.
How to do with 2013?
Thank you
Diiity
Hello
it is necessary to see the type of 3D printing targeted, but in the absence of a thread function it is possible to use the swept boss function with a trapezoidal profile following a helical curve (helix). You will find tutorials on youtube if needed.
Hello
Propeller sweep. Galley.
Well I'll see.
Thank you
It's okay, I succeeded with the spiral method but not on the first try.
diiity