Technique: truck tipper

3D Design Volume Model
1

I am looking for technical information on skips :

Is there a standard on the position and size of the " Coal Gates" ?

 

2

I searched a bit.

 

I think that if it's so hard to find, it's because there isn't one^^ :D

 

to be confirmed anyway;)

2 Likes
3

Find out about these standards:

 

NF R17 108

NFR 17107  for hydraulics

NFR 17108 for cradle rings, etc.

2 Likes
4

Did you find the answer then?

 

I'm interested in that too^^

5

I don't have access to the standard (you have to pay !!!)

For the position and dimension, from what I have noticed, each builder positions it where it wants.

I contacted a tipper manufacturer by email (benne-cmb), but I have not heard from him yet.

The only document with dimensions that I found is this one below, however, there is no dimension of the hatches: 

after I looked for 3D models of "Cereal Dumpsters" (with coal gates), I haven't (yet) found it.....

6

What is the ref of the standard?

Google: "standard" filetype:pdf...

1 Like
7

Well seen stefbeno, sometimes there are pdfs of standards available on the net (often in English).

8

and yes it's true for the normative

You have to go through the purchase box

and it's not always giving ;-)

but it is part of the operating costs for a company so you shouldn't deprive it ;-)

See this link

https://www.boutique.afnor.org/recherche/resultats/mot/benne/categorie/normes

@+ ;-)

1 Like
9

After multiple searches, there is no standard.

Each manufacturer does what it wants.