TOOLBOX - Configure component positioning

3D Design
1

Hello

After adding components to the TOOLBOX library, I want them to pre-stress when inserting just like when inserting a screw. 

Let me explain: 

When, from the toolbox, a screw is inserted, it is requested to select a face/edge in order to prestress the screw. Thus, the screw is constrained in my assembly. 

I created, in sldprt file, plugs and added them to the library. From an assembly I can insert the cap and choose the configuration I like. However, I am forced to totally constrain the component.

(the caps go in square, rectangular and round tube) 

So I want to know if there is any access to the parameter for the placement of imported components in the toolbox library. 

Thank you in advance.  

2

Hello, if I understand that you are looking for automatic constraints, look at the side (Constraint reference), 

2 Likes
3

Hello

Thank you very much, I didn't know about this function. 

1 Like