Drawing an Ovoid in a Sketch

benjamin_co · December 21, 2016, 3:19pm

Hi all!

I'm working in SW 2013, and I'm trying to draw a curve in a sketch via an equation. This curve is an ovoid type "Egg of Granville".

Equation of the curve here:

Would you know how to make it appear in the sketch via the dedicated sketch function?

I tried in all directions, but impossible to get a result :s I must do it wrong.

A big thank you in advance,

Youngest child

Frédéric · December 21, 2016, 3:31pm

Hello

Have you tried to build up some point on your curve and then run a spline through those points?

FLOP1 · December 22, 2016, 7:33am

Hello Benjamin,

Is that what you want?

(link in SW2015)

egg.sldprt

stefbeno · December 22, 2016, 7:52am

It's full of choli.

Benjamin, what did you try? Where do you get stuck?

attached is a screenshot of Flop's play. I tested in SW13, it works.

gt22 · December 22, 2016, 11:21am

attached file SW 2012

@+