Hello
My father is an engraver on stele and I try to help him find the fonts for engraved. I tried what the font but it didn't work. I hope you can help me. Thank you in advance for the answers. I have some others to find but I can't post them.
Look with him on dedicated sites, what suits him best:
But don't expect to find exactly the same font as on your drawing.
On the other hand, fonts that look like it, why not, after that there are plenty of them, only the person concerned will be able to say if it suits him.
Example:
And if one of them suits you, you download it and install it.
2 Likes
See also some " Laser " fonts and their installation instructions:
https://forum.mycad.visiativ.com/t/export-dxf/107003/8
and others here:
https://fontmeme.com/polices/polices-grave/
2 Likes
Hello and welcome,
What complicates, if not impossible, the task of recognition tools is the way your policy is recorded. You should trace/trace the outlines of the characters in a much distinct way. And of course, eliminate all other visible writings in your photos, such as the business card that can be seen under your sheet. Crop or use a plain background so as not to interfere.
A question comes to me:
Would I go to hell if I had a font engraved on my grave that is not free of rights?
2 Likes
Hello
I did a font test following your drawing, and I found this one.
Hello, thank you indeed the font is very similar. I'm going to look at it right now. Thank you again.
Indeed, quite close apart from the R.
1 Like