Hello
How to configure the default properties of the thickness and line type that delineate partial sections and detail views.
Hello
How to configure the default properties of the thickness and line type that delineate partial sections and detail views.
Hello
I didn't really understand what your problem is, look at the Solidworks online help you will find your problem there.
http://help.solidworks.com/2012/french/solidworks/sldworks/t_section_views_models.htm
Dimitri
See this link
http://help.solidworks.com/2015/french/SolidWorks/sldworks/c_modify_section_line_properties.htm?id=09930824d8c04b3293683c454567c981#Pg0&ProductType=&ProductName=
You can change a section view or a flattened section view by editing the properties of the section line. You can set these properties before, during, or after the section view is created.
Table of Contents
@+
Hello
If you want to change the line type and weight of the detail view profile, it's in Options>Document Properties>Views>Detail.
On the other hand, for partial cuts I don't understand what you want to do.
I would like to draw your attention to the fact that if you assign your section / view in detail to a layer, the line properties of the layer will take precedence over that of the document properties.