cph
1
Hello
Since the 2013 version of smartbom creator,
a "Save modified documents" window appears for each assembly encountered in the BOM.
This is annoying because you have to be there to validate otherwise smartbom stops.
Is there an option or trick to no longer have this window
Knowing that the initial assembly is always rebuilt and completely re-registered before launching smartbom.
Slts
Philippe
doc5.doc
The problem should not be with SMARTBOM but rather with your SolidWorks options.
See if your system options match the attachment.
option_systeme_ref_externe.jpg
cph
3
Hello
I have the same options as on the attached part
I restarted smartbom and I still have the Pb
In your general SMARTBOM options, you would not have the following checkbox:
"Reconstruction at each creation of a nomenclature"?
if YES, do a test by unchecking this option.
option_generales_smartbom.jpg
cph
5
Thanks for the help
I unchecked the box and restarted SW
now it works perfectly
thank you again