Hello everyone,
I'm making an evolutionary conical worm screw (change of section), the idea is to start from a section of 100*8 flats and end up with 40*8. I managed to make the screw (see attachment) but it's the change of section that causes me problems.
Thank you in advance.
If I understood correctly
The best thing to do is to do everything in 100/8
and then you create your cone by removing material
@+
Hello
Check out this video, I think it's going to help you.
https://www.youtube.com/watch?v=D0UzIq6igs4
Can you post your file so we can test?
You have to do a smoothing rather than a sweeping