Auxiliary view

2D plans Layout
1

Hello

 

I duplicated an MEP from room A to re-assign it to an almost similar room B.

But in the new mep B, the auxiliary view does not seem to be taken into account. It still appears, the dimensions are correct, but the drilling axes are off-center.

And when I re-select the edge to redo an auxiliary view, the index goes back to A as if the first one didn't exist (the 2 views are on the same sheet). And everything is going well.

 

So I wanted to know if there was a way to properly re-assign the auxiliary view by reselecting the edge?

 

FYI:  - SW12

                - ctrl Q doesn't change anything, same for ctrl B

 


2014-07-29__vue_auxiliaire.png
2

Hello

 

 

You can edit the sketch indeed, see the help  : 

http://help.solidworks.com/2013/french/SolidWorks/sldworks/t_edit_sketched_line_used_to_create_auxiliary_view.htm

1 Like
3

Or see these links:

http://help.solidworks.com/2013/french/SolidWorks/sldworks/t_edit_view_arrow.htm

http://help.solidworks.com/2013/french/SolidWorks/sldworks/HIDD_DVE_AUX_VIEW_PROP.htm

1 Like
4

Hello

 

What manipulation did you do to re-assign the new shot to room B?

References in the opening window?

 

@+

 

1 Like
5

@lucas P: solution with the right click: I don't have the possibility to edit the sketch. I must have missed something.

 

@coyote: Yes, reference to opening the file.

 

In fact I'm in this case (see image) where I would have to re-assign the sketch of view C.

 

 

 


2014-07-29__vue_auxiliaire_-2.png
6

By still testing with your solutions, by reversing the direction  of the auxiliary view projection arrow 2 times, it reconstructs the view correctly.

 

So I think that reselects the sketch correctly...