I am currently doing a motion analysis with the fall of a bullet into a pipe, which would then be pushed by a piston before being sent by two friction wheels. Only, when I put a contact between my ball and my pipe and I start the animation, it gives me what's on the attached image. Does anyone have an idea to solve this problem?
If you create an axial line of your vertical tube
and that you create another axial line to the right of your gutter
put you create a mini radius between these 2 lines
you constrain this sketch with the axial point of your bullet
so your bullet shouldn't go through your gutter
Try it for the beginning of a walkthrough
@+
Hello
Are you sure of your contact? Check the it's not normal for him to go through
@+