Hello
I have an axle topped with a cam that pivots.
The cam passes between 2 bulkheads and must straighten on either bulkhead at the time of the collision so that it passes.
I don't know how to make this constraint.
Thank you
Diiity
1 Like
Hello @diiity
I didn't understand anything so here's what I understand
Your cam can collide (stop) either on one bulkhead or on the other opposite.
This means that the maximum travel is limited to a certain angle.
Normally with an angular stress this should work on the attached drawing (look at the marks)
Select Constraint ==> Select the two stop faces concerned
Forward (mark 1) ==> Angle (mark 2) ===> maximum angle (mark 3) ===> minimum angle (mark 4)
Kind regards
4 Likes
I had already done this manip but it only works on one side.
I attach another more explicit screenshot. These are plan constraints.
The angle constraint can work but to complete the answer of our friend @Zozo_mp ,
You must add a plane to orient the angle ("Reference entity" box) and choose your plans so that the angle does not change direction.
In your case, you must take a perpendicular plane so that the angle evolves between 60° and 120° (if the travel is +/-30°).
1 Like
It's okay, great, we had to take a perpendicular plane
1 Like