I want to make a bend using the " Sheet Folded on Edge " function which allows me to make a bend as well as to edit a sketch. However, the setting of the angle I want is less than 90° (it is at 120° on the screenshot below). Is it really impossible to achieve this in SolidWorks?
Hello rvouillat, And welcome to the community,... I'm not a boilermaker or a folder,... I would first fold the fold that you want that is in your screenshot, then I would fold the other two. (To be seen). But for my part, I couldn't say if it's industrially feasible. @+. AR.
Thank you. I'm not talking about the realization of the element on the screenshot but about the possibility of having an angle adjustment of less than 90° in the setting of the function.
Hello rvouillat and welcome, I don't see why SW refuses to make this fold. The settings seem to be correct, as well as the method. I did the same thing and it works