I wanted to cancel the "restore" command I did in "option, file location, background" but I don't know how to do it.
Thank you for your answers.
I wanted to cancel the "restore" command I did in "option, file location, background" but I don't know how to do it.
Thank you for your answers.
You don't have a REG file of your configuration???
To my knowledge no restoration possible unless you have a REG file to put your options back.
Agree with @Happydad, you should have made a backup, either an export of your registry or with the wizard to copy the settings
The restoration should be restored in fact ... Programmers will tear their hair out with such cases!
I agree with my teammates above, you should have made a backup of your config (I'm ok, as long as you didn't make the mistake, you don't see the point of it xd)
Hello
One solution that can work at your own risk is to close SolidWorks from the task manager. Typically, when SolidWorks crashes, configurations that change during the session are not considered.
Thank you for your answers. I don't have a REG file. I solved the problem by recreating my options
Ok, remember to make a backup in case it happens to you again