gerald
1
Hello
I did a search for the anticolision between 2 pieces but I couldn't find a procedure or tutorial
Under solidworks 2014
I would like to create a function to prevent a shaft with flat fixed by a ball joint function at the end of the whole in a tube.
I tried to go through some constraints but my axle goes into collide with the tube (and comes out of it).
I'm sure I've heard of an anti-colision function between 2 rooms but I can't find it.
Thank you in advance
Gerald
gt22
2
it is in the assembly to move the component
See screenshot attachment
capture_deplacer_le_composant.png
4 Likes
The collision detection function is more for checking or finding a collision position
than to create a constraint, do not confuse
3 Likes
gerald
4
Hi gt22
So the anti colision only works when you are in the move component mode, it does not apply in the assembly in normal mode?
gt22
5
Yes the detector tool as its name suggests (collision detection)
It detects a collision and only works on assembly constraints
it is there to warn you that there is contact of parts
which is very useful since by this action it gives you
dimension or angle values
so you can configure your limits of movement in the constraints
@+;-)