Hello
I currently use a cartouche that takes up the mass property of the part used for drawing.
The weight is therefore displayed with 2 decimal places after the decimal point.
I would like to round this mass to the gram.
Thank you for your answers.
Jasz, SW 2015
Hello
you have to go to tool==>option==>document properties==>units then in mass/section property in the 1st line (length) you put .1 in decimals...
Or else at the bottom right of the screen like the attachment...
Hello
You must use the options available in the part document at the level of the mass properties:
This should normally modify the value to 2 decimal places in the cartridge.
Thank you it's all good:)
Hello ac cobra 427,
I have the same problem except that I can't change the decimals as you say. The box is greyed out, do you know why?
Hello
On your image, the box doesn't seem greyed out:
Kind regards
D.Roger, I'm talking about the mass, you have circled the length.
If it were that simple, I wouldn't have asked for :)
Yes, and the correct answer from this post is:
It was so simple...
Kind regards
D.Roger, as much for me, I wanted to go fast and I didn't think that the decimal squares were linked.
Indeed it was so simple but not necessarily logical.
Have a nice day.
you have to go to tool==>option==>document properties==>units then in mass property/section in the 1st line (length) you put .1 in decimals...