Hello
I am currently on an assembly and adding holes to it using the "drilling wizard" function in "Assembly functions".
When I opened one of my impacted parts, I noticed that the holes were not reflected.
Is there an option to select or is it just impossible?
Thank you
To propagate the function to the piece, you must check this:
On the other hand, I prefer the solution where we edit the part to make the holes in this part directly and without reference related to the assembly.
10 Likes
I'm thinking of breaking the ties afterwards, it would allow me to save time
Thank you very much
Not sure that you can break the link with the function in the assembly, in this case it is better to edit the part from the assembly and do the drilling function even if it means dimensioning in relation to other parts and then breaking the link.
Edit: Finally it works by breaking the link. It's up to you to choose the solution that suits you best
2 Likes
Hello @sbadenis ,
Since you have tested, in your opinion, is one method faster than the other?
2 Likes
Personally, I don't like to create links. But in terms of speed no big difference in itself.
On the other hand, be careful, the function remains both in the part and in the assembly after breaking the link.
4 Likes
Thank you for the clarification on the persistence of the function.
This is not anecdotal.
2 Likes