Hello
I'm looking for how to put an axis in the center of a room. Let me explain, with Solidworks, it is possible to put a construction line in the annotation tab. We select two strokes and it automatically puts it in the middle of these two strokes.
I would like to do the same on Topsolid but I can't find anything that allows me to do it. Manual axis additions are only for holes. And the automatic axes don't allow you to do that.
Is there anyone who has a trick?
Thank you.
Hello
I couldn't find anything on the subject, maybe it's impossible!
Hello
As a PL, I didn't find anything.
And if you tinker... You make a small hole in the middle of your piece and you create your axis manually and then you close it. You'll have your axis in the middle of your room.
Hello
So after several days of searching, I finally found it. You have to go to the wrapping tab ==> Manual axis ==> check the small box with two circles and two axes which is called two elements and then select the ends of the part.
It therefore puts the axis in the center of the two selected lines.
It was so simple that we didn't find it right away.
Navy.