Hello
Under Inventor 2013, how do you break a subset that is in another subset.
Like the SolidWorks decompose command.
I want to recover the parts that are in the sub-assembly and make them go into the general assembly.
Thank you.
A+
Hello
Under Inventor 2013, how do you break a subset that is in another subset.
Like the SolidWorks decompose command.
I want to recover the parts that are in the sub-assembly and make them go into the general assembly.
Thank you.
A+
Hello
Open your assembly, then open the sub-assembly(s), then each part that is in your sub-assembly, save them, and reassemble with all the parts. And you'll have an assembly with all the pieces and no sub-assembly in your whole.
Michel G.
Hello
Right-click on an assembly, leave the cursor on the component, choose promote/remove (demote).
Right Mouse Button on the parts/assembly.
Hold your cursor over Component.
Select Promote or Demote.
Hello
Thank you to everyone who answered me, and sorry for the lack of reaction, but on the go....
The 2nd solution, I don't have the promot/remove (?) command but I have the integrate/descend command.
It only allows you to go up sub-set by sub-set, which is a bit long.
So I'm always looking for another faster solution, thank you.
A+