Hello
In the case of a part that has different bores that are on a different axis from the Z axis.
How can we define the contact/bearing link in the simulation module in this case?
Should we go through an auxiliary coordinate system that will give a systematic Z correspondence, to each surface designated by the defined charge?
Thank you for the help provided by the forum.
Hello
Yes, in my opinion, we need to create a marker with Z pointing in the right direction.
Hello
Can you specify a little bit that "" would have different bores that are on a different axis of the Z axis." Not obvious on the image and especially without knowing the different loads. How many bearings are involved and what is the relationship between the different loads in different bores.
A small sketch or the full picture of the system would be welcome.
Kind regards