I would like to represent a bent sheet with a perfo sheet without repetition of holes because it will weigh down my file.
How would you do it?
panier.jpg
panier.jpg
2 Likes
via a texture applied to your sheet metal
See this link
http://www.lynkoa.com/forum/3d/nid-d-abeille
the same about the same
except
the size of a whole sheet 2500x1200
which was not the case in the previous message
in apparenece and translucent support piece
I made a red boss on one side to show the transparency
See the attached file below
@+ ;-))
7 Likes
Hello
Indeed, as @gt22 says, all you have to do is apply a texture to all the surfaces you need.
The effect is still quite crude but for the representation it will be enough not to weigh down the file!
1 Like
A function repeat test here
attached file wait for loading time ;-(
@+ ;-))
repetitio_de_fonction_stat.sldprt
@+
1 Like
Hello
Here's where to find this appearance.
5 Likes
Hello
What is also not bad would be to do a repetition on a small circular area in order to show what the sheet metal should look like.
1 Like
Otherwise, I haven't tried, but you can model this perforated sheet metal, render, make a capture, and then save it as an appearance. It can be useful if the holes are not round.
2 Likes