Hello
My problem is when I do sheet metal work in the corners there is always material left from the radius, I wanted to know if he had a technique to eliminate this problem
Solidworks 2022 SP4.1
screenshot_2.jpg
screenshot_3.jpg
Hello
My problem is when I do sheet metal work in the corners there is always material left from the radius, I wanted to know if he had a technique to eliminate this problem
Solidworks 2022 SP4.1
Hello
In fact it's very simple, just check the box "Adjust side folds".
And this removes the small piece of sheet metal remaining in the fold.
Kind regards.
or you change the type of fold and you can also adjust the folds with dimensions
or you make a sketch and a removal of material