Hello
Is it possible to set the groove stress so that it is set to centered (not free) by default?
Thank you
Hello
Is it possible to set the groove stress so that it is set to centered (not free) by default?
Thank you
Hello
You can use the display states / configurations...
Hello
When creating your groove, you used an oblong for material removal. You can use the point from the center of the oblong sketch for the constraint.
A priori no:
dixite the SW aid
2017 What's New in SOLIDWORKS - Path Constraint Support
The question is whether we can adjust this parameter when opening SolidWorks, right?
No option for this setting
+Alain.ERP: Yes, that's right.
I already saw in an old Lynkoa tutorial that you can modify Property Manager settings (put default checkboxes, I think).
It was a manipulation to be done at the registry level.
I'm trying to find the info.
I think that's the kind of thing you need.
Ok thank you Alain
Hello forum,
Very interested in this post, Aliende did you dig into the subject of the registry?
Kind regards.