Cut a part that has the property "isfastener" SW2021

2D plans Layout
1

Hello, I have a room that has the property " isfastener " at 1 and is therefore not cut.
BUT on 1 view only I would like to be able to cut it.

I looked but didn't find a solution, I don't know if it's possible but if anyone knows??

Thanks in advance

2

Hello and welcome;

Although you should never cut screws, Solidworks still allows you to overcome:
Or when the cup is created:
image

Or after placing the 'right-click' section view in an empty area of the targeted view + property:
image

3 Likes
3

Yes I had tried, but it doesn't work.
I don't know why.

Precision: this is a section made in a cross-sectional view.
I unchecked the box in the 2 cups to see but nothing helps.

Thank you anyway.

4

If the view does not update, you must uncheck and then recheck the Exclude fasteners option in the view properties, then rebuild the drawing (Ctrl+Q).
(see to rebuild between each change of state of the checkbox...)

but it doesn't work every time and not on all versions of Solidworks ... So with a cup within a cup it's not won.

uhhh... Good luck. (hoping that your version of Solidworks is at least sp4, if not...)

Note: I'm not even sure that you can change the state of one cup within another.