Creation of additional 3D profiles to the mechanically welded repertoire

Out of category
1

Hello 

to mechanically welded elements

On  the basis of a very simple sketch, I symbolize the section of a sheath by 2 concentric circles duly dimensioned 

(small and large diameter) and center attached to the origin of a 2D plane

In the "weldmentprofiles" directory  I created  an additional directory "elec"

and I saved my sketch as an SLDLFP file

and the sketch was added to the recorded design bilio

When I select my new welded element and  insert it into my 3d sketch (off) 

The sketch does appear to be at the origin of the group but the profile is not extracted

What is going on? 

Where is the error??  

 

2

Hello

Can you indicate the version of Solidworks and send an image of the problem?

Cdlt

3

Hello

I don't know if I understood the problem correctly but when saving the profile the sketch must be selected in the FeatureManager


mecano.jpg
4

Thank you for your answer 

Attached Sketch Plan Enabled and Disabled 


ecran_esquisse_icta_20_2.png
5

2nd plan 

after activation 


ecran_esquisse_icta_20.png
6

I think this comes from the fact that there are 3 closed sketches. From memory, you only need 2 at most.

7

No, we can put 2 closed sketches, 

I found the problem, I had to be an administrator 

I rectified it, it's ok, 

Thank you all, have a good weekend 

8

Hello LARGHETTO

If the solution to the problem is your own answer, why didn't you tick it?

Cdt

1 Like