Create a thick surface that takes up the junction of two tubes

3D Design
1

Hi all

I am looking to create a thick surface of 4mm Maxi, using the junction surface of two tubes, in order to represent a lattice with a mesh of 15x15 Maxi (thickness 4mm Maxi).
I'm using Solidworks 2022SP4.
Attached, SW model with screenshot, hoping that I can make myself understood...
Deviation.SLDPRT (500.7 KB)

Surface treillis
Lattice Surface686×705 61.5 KB

Thank you in advance.
@+.
AR.

2

Like this?
Deviation_SS.SLDPRT (454.8 KB)

2 Likes
3

Hello Silver_Surfer;
Thank you very much, that's exactly what I was looking for.
@+.
AR

4

Hello again Silver_Surfer;

I'm taking advantage of you or maybe I'm abusing you a little.
I would like to make a 15x15 mesh with a thickness of 2mm with material removal but that it be uniform over the entire surface of the junction of the tubes.
Find what I know how to do on my side, I'm still scratching to find the solution, and I thank you again for your help.
@+.
AR.
Deviation00.SLDPRT (785.9 KB)
Deviation01.SLDPRT (2.2 MB)
Treillis00
Treillis01

5

HELLO AGAIN,
I just found the solution thanks again!!
Here is the model=>
Deviation02.SLDPRT (814.9 KB)
@+.
AR.

6

Your Deviation02 file matches this image:
image

Could there not be a mistake?

7

I proceeded like this:
Deviation01.SLDPRT (3.2 MB)

8

Silver_surfer,
No deviation01, the second is my last solution found.
But thank you very much for your last proposal.
@+.
AR.

1 Like