Hello
Following this post: https://www.lynkoa.com/forum/solidworks/mod%C3%A9lisation-dune-h%C3%A9lice-davion
I did a straightening but strangely, I had to do it in 5 times which I didn't understand.
The rendering is as expected except that I have a demarcation between each smoothing.
Can you tell me where I went wrong or tell me how to remove the demarcations?
diiity
creates another 3D sketch
via a spline for your leading edge
and select your sketches in order
See attached image
@+
Well done@GT22
@ diiity
A great classic, you should not hesitate to have several guidelines, especially on complicated shapes, var otherwise SW tends to go as short as possible between two profiles. It's like a two-point or four-point spline, it doesn't give the same results.
Cdlt
Hello
I don't understand, he does this to me, and when I validate it he doesn't take it
Attempt to deport each blue dot
at the other bottom corner
and make sure that the line is at the same angle
or managed via a third 3D sketch
In Surface
The bottom stitches, I've already done it.
Yes, it works in surface and with low points.
But why not in volume?
In general it's easier in surface for sweeping and smoothing at least we go further without sw telling us I don't agree
;-)