In my assembly, I no longer have access to constraints.
There must be an option to check or uncheck but I don't see which one.
In the display of the tree I have not found.
pb_asm_2-09-13.jpg
pb_asm_2-09-13.jpg
Hello
Maybe the fact that you have opened your set in light limits some access to the tree?
At the bottom of the tree it seems that the constraints cannot be developed, so in theory there should be none, if you right-click on a component and see the constraints there are?
No, there are no constraints if I right-click and then see the constraints on one of the parts of the asm.
However, all the pieces are well fixed (there is no "-" in front of the pieces)
Are there several configurations in the assembly? If so, is the problem present on all configurations?
Is it a file from an old version of SolidWorks or was it created in the version you are using?
In your construction tree you have group containte assembly 1
Look at the
I had 2 configurations.
In the 2nd configuration, no problem.
So I tried to delete the config in which I didn't have access to the constraint group.
Unable to delete this configuration.
Worse, if I add a new configuration, I have constraint errors everywhere.
This assembly is from an "old" assembly (so from an old version of SW), I think the assembly is corrupted ....
It's not complicated, we're going to rebuild it properly!!!!
I've already seen the case in old assemblies converted with the first version of 2013 constraint problems that "jumped" I don't know if it's exactly the same problem but it looks like it.