Draftsight 2015, accrochage objet

3D Design 3D Animation and rendering
1

Hello

Since I switched from draftsight 2014 to 2015 I have a small problem with object snapping.

I draw 2 parallel lines and I want to draw a perpendicular one connecting the 2.

Line order, I start from the 1st parallel straight, I go to the 2nd and normally with the hooking I come to grab it directly.

But since the 2015 version it doesn't fit well on the 2nd. If I don't zoom in as close as possible to be really on point, it always stops a little before or a little after.

And when I get close to the point I have 3 little yellow circles that appear at the bottom right of the pointer, which I didn't have in the 2014 version.

If anyone has an idea.

Thank you

2
Hello, there are several esnap etrack etc buttons at the bottom of the screen. Try to change these options.
3

Hello, I did a tour in these settings but it doesn't solve the pb.

I think that this is a flaw of this 2015 version and that there is unfortunately no solution.

It forces me to zoom in when I do my hanging, it's not very annoying in itself but as it's an operation that I do dozens of times a day, it annoys me a little:D

1 Like
4
Indeed, as you can see in the link below, some people have this same problem. We have to wait for an update... Search snap in English:

http://www.cadoasis.com/draftsight/troubleshooting/

1 Like
5

Thanks for the link.

Well, all we have to do is wait for them to release a patch:)

1 Like