Perform a Weld on a Bending Part (SW2013)

Out of category
1

Hello

 

I have a little problem and I can't find the solution,

I have a part see the attached file, these in fact a folded sheet metal

and I would like to make a weld at the 4 angle of the sheet so where the faces meet

but the problem is that when I use the fillet welding tool it marks me

that faces 1 and faces 2 must belong to distint bodies

Being the first time I use the tool on a bent part I don't really see what it means by the :x

 

Could you tell me here, what I would like to do and what is possible or simply not possible

because I struggle a little with the welding functions

 

Thank you in advance for your answers

 

Steve


cache_panneau_de_controle_2.sldprt
2

Hello

 

Using the "Soldered Corner" function, it works (see attached file).

However, if it is not necessary for it to be visible (as is often the case when making a weld and the "flange" is not essential), you might as well notify it only on the 2D plan model.

 

I find the soldering function a bit "light" in solidworks ...


cache_panneau_de_controle_2.sldprt
1 Like
3

Hello

 

Thank you very much, I didn't know that this command existed, because on my sheet metal toolbar it is not displayed :s

 

But I found it in the commands and I added them after seeing the file you had attached to me

 

thank you again