Unusually long DXF and DWG recording SW 2018

Hello

Since the switch to SW 2018 sp3, the time it takes to save drawings to DXF or DWG is abnormally long.

Is there a trick? (problem encountered on all PCs of the BE)

Thank you

 

1 Like

Hello

I have the same problem. Do you have a trick to speed up registration?

 

 

 

1 Like

Good evening VLG

Which version of SW do you have?

Kind regards

SW 2019 SP4

Hello

Well come  I have the same problem (SW2019 SP4) . I don't want to scare you but I contacted the hotline and the answer was

  "can do nothing,  no solution"

May the force be with you.

 

1 Like

Simple trick, to save a lot of time in exporting dwg, dxf when you can you have to export only the view.

It only exports the view without the cartridge and for a factory layout, processing time 8 hours for the complete plan and 10 minutes for the view (top view). While the plan only contained the top view...

 

To do this, click on the view, then on the left make the view saved as.

With a little luck it will be able to help some of them.

For me the top view (layout plan) responds to 95% of dwg exports too long. And at worst I reconstruct view after view.

4 Likes

Otherwise with solidworks 2020 you open the plans in a flash! According to SW of course...

And for export?

 

Anyone to check if this is true?

2 Likes

Thank you sbadenis for this tip of exporting only the view!

1 Like

Thanks for the trick indeed it's very practical.