Hi all.
Listen, I have to thicken the bottom of a record but gradually, that is to say 2 mm in the center to end up at about 3 mm on the end, it's an imported body, I can't rebuild the model, I'd like to work on the body with surfaces or others without redrawing everything.
An example in please is attached for testing.
Thank you in advance.
variation_depaisseur.. Step
If your real model is like the stp file, don't you make a simple revolution with the desired shape to go to 3mm thick?
Hello, the shape is more complex, in reality I have redesigned it, see below, I would like to reach 3 mm at the end of the arrow.
Thank you.
variation_depaisseur.. SLDPRT
You can do this with two adjusted surfaces, see example attached.
variation_depaisseur_surface.sldprt
3 Likes
roms
July 20, 2016, 10:36am
5
And with the dome function?
See attached.
variation_depaisseur.. SLDPRT
1 Like
Thank you very much for your answers, the solution with the surfaces is good, I'm trying on the other hand , rom' s your file does not open.
roms
July 20, 2016, 11:31am
7
I'm on solidworks 2016 I think that's why... Here is in step
variation_depaisseur.. Step
1 Like
roms
July 20, 2016, 11:59am
8
and the without using the continuous dome checkmark
variation_depaisseur.. Step
1 Like