Hello
I can build a master sketch (ES001) in an assembly (ASM001). I can then create parts from that sketch. If I modify my sketch, the parts in my assembly will adjust according to the changes made to my ES001 sketch.
Secondly, I would like to build a second assembly (ASM002) with again a master sketch but I would like this sketch to be the ES001 sketch.
At this point, if I go to make changes to ES001, I should have changes to ASM001 and ASM002 that will be done.
Do you have any suggestions for reproducing this easily?
Thank you.
Hello, it's about creating a skeleton, a part with only sketches, plans or others. And you can insert it into all your assemblies.
8 Likes
Hello masterfab,
I also agree with dominique.naudet's solution, which allows me to manage the sketches.
For my part, I use configurations of the part as well as for assembly.
…@+.
AR
OK, thanks guys!
I'm going to try this technique.